Quickly solve ELV Module / Steering Lock Module problems with this BMW Mini Cooper ELV Emulator!
Remove the 4-pin connector from your ELV / Steering Lock, attach the connector to the emulator, and start the vehicle.
• Works with BMW CAS Model Types (CAS2, CAS3 & CAS3+) which are found in BMW E60, E87, E90 Chassis (3 / 5 Series) and Mini Cooper.
• Emulates the ELV (Steering Lock Module).
• Plug and Play - no additional programming required. In some cases, you may need to clear the CAS fault memory (DTCs) with a diagnostic scan tool. After the emulator is connected correctly, and the led flashes five times, there is a problem that needs additional attention before this emulator will solve your problem. If the led light comes on a single time and then goes out, this indicates that the CAS is accessing the ELV Emulator properly and locking and unlocking commands are able to be sent and received.
This emulator works with both 3 pin and 4 pin connectors (There is no need for the fourth pin because it's for mechanical drive voltage to power the ELV motor and isn’t required by our emulator.)
You should remove all DTCs with a diagnostics scan tool after installing the emulator, for the best results.
Compatible with:
3 Series:
• BMW E60
• BMW E61
• BMW E62
• BMW E63
• BMW E64
5 Series:
• BMW E81
• BMW E87
• BMW E90
• BMW E92
• BMW E93
• Mini Cooper R55
• Mini Cooper R56
* General Instructions
1. Make sure the steering wheel is unlocked and the car is running (if not, reset the CAS counter)
2. Remove the 4-wire connector from the steering wheel column
3. Locate cable 1 from the wiring harness connector or steering column connector
4. Connect your wiring harness connector (black 4-wire connector) to the Emulator, so that it matches pin 1 on pin 1 emulator in your wiring harness.
5. It is best to secure the connector so that it is not loose and is in good contact with your wiring - Best soldering!
-
Product Type
Emulator
-
Item #:
132019
-
SKU:
GC-1303
